The clutch of the car is located in the flywheel housing between the engine and the gearbox. During driving, the driver can step on or release the clutch pedal as needed to temporarily disengage and gradually engage the engine and the gearbox to cut off or transfer the engine Power input to the transmission. Automobile clutch is our company's main product, and its use has also become a favorite of workers. How do you check the car clutch? What do you know about these? Follow us to find out.

1. Under the engine idling state, the clutch can only be cut off when the clutch pedal is pressed to the bottom; or the clutch pedal is stepped on, it is difficult to gear up or the gear gear has a harsh impact; or the clutch pedal is not lifted after gearing, When the vehicle starts to drive, this indicates that the vehicle's clutch is not completely disengaged. 2. The clutch slips, the reasons are: the free travel of the clutch pedal is too small, the separation bearing is often pressed on the diaphragm spring, so that the pressure plate is always in a semi-disengaged state; the clutch pressure plate spring is too soft or broken; the clutch is connected to the flywheel Loose screws, etc. There are many economical cars that have been used for about two years, such as Alto, Xiali, Flair, and Big Dipper. Most of the original owners are new drivers and often have the above failures. 3. It is also abnormal if abnormal noise occurs during the use of the clutch. The cause of the failure is: the separation bearing is seriously worn, the return spring of the bearing is too soft or broken, and the diaphragm spring bracket is defective.

Through our introduction, you should know more about the clutch of the car. If you want to know other performance information about this product, just take a look at our company, or log in to the official website and communicate with our customer service, our staff will bring you the most enthusiastic service. Contact: Tel: 0576-87277009 Fax: 0576-87277006 Mobile: 18057683359

Jiangsu Huayu Automobile Industry Co., Ltd. (automobile clutch manufacturer) was established in 2003 and covers an area of 106,600 square meters. It is a professional manufacturer of clutch systems, covering the supporting and after-sales markets. Our own brands: LOOK, ABOBA, PANDA.